Header Specs:

This header is designed for any tube size up to 2 ½” with any collector size up to 5” or our collector mufflers in any size up to 6”. The back tube on each side goes around the chassis for added oil pan clearance there may be some tire interference at a full turn. Measuring from the side of a stock oil pan we have 4” on the passenger side and 4 ¼” on the driver side of space for large sump kick outs or dry sump oil systems. This also allows for easy access to the oil filter and starter. This header requires a mini starter. Ground clearance is very good the bottom of the header is about ¾” below the bottom of a stock oil pan. Spark plug access is very good. The header is designed for AJE side motor mounts or motor plates but the motor needs to stay in the stock location. The steering column must be installed per AJE instructions.
This header is NOT intended to fit air conditioning, clutch linkage, power brake booster or column shifter linkage.

Header Installation:

This design is built with individual tubes and a slip on collector making it very easy to install. On both sides start from front to back installing one tube at a time, only snug the header bolt as you go until the collector is installed then go back and tighten all the header bolts.
Refer to our header installation tip’s page for additional information.

Thank you for selecting Lemons Headers!
If you have any questions give us a call at 805-239-8998.