#SBR-120 – ’93-’02 Camaro Small Block – SB Race header for stock chassis with Moroso solid side mounts or motor plates also BMR “K” member with side mounts or motor plates or AJE “K” member with motor plates onlySB Race header for stock chassis

$1,950.00$4,200.00

SKU: eafc28ac2f16 Categories: ,
Have a question about this product?
Contact Us

Header Spec’s:

This header is designed for any tube size up to 2 ¼” with any collector size up to 4” or our collector muffler up to a 5” size. All of the tubes are inside the frame with good ground clearance and spark plug access. It will fit any mini starter a full size GM starter will not fit. This design will fit side motor mounts or motor plates. The passenger side is the most restrictive. Depending on the tube size you may have to slightly trim the bottom of the mid plate and the outside corner of the starter aluminum mounting block. Measuring from the side of a stock oil pan on the passenger side we have 3 ¼” of room for an oil sump kick out and on the driver side we have 2 ½” at mid pan and 3 ½” of room at the bottom of the pan. If there is no kick out on the driver side the oil filter is accessible. If you are using a Lakewood style scatter shield you may have to trim the outer edge of it below the starter area. The driver side header is close to the steering column, depending on the tube size you may have to replace the factory rag joint with a smaller “U” joint. The header will fit a hydraulic clutch system only, but is not intended for air conditioning or column shifter linkage.

Header Installation:

We build our race headers with individual tubes and a slip on collector for easier installation. Depending on tube size and oil pan kick outs you may have to remove the starter and steering column section between the 2 “U” joints.
Install both sides from front to back. As you install each tube only start the header bolts leaving them loose enough that the tubes can move freely. Once all the tubes are in snug the header bolts, but don’t tighten them until the collectors are installed then go back and tighten all the bolts.
Refer to our header installation tip’s page for additional instructions.

Thank you for selecting Lemons Headers!
If you have any questions give us a call at 805-239-8998

Additional information

Metal

,