Lemons Header Logo


Product List
Price List
Customers Cars
Install Tips
Contact Us
Product List



Header Specs:

This header is available in any tube size up to 2” with a 3 ½” collector. All of our headers are hand made so we can make them for any engine deck height and for any aftermarket cylinder head. All of the tubes are inside the frame and the header has excellent ground clearance. We used a Milodon oil pan #30900 to design with and the bottom of the header was ½” higher than the bottom of the oil pan. The available room for an oil pan kick out sump is 3” on the passenger side and 4” on the driver side, measuring from the side of a stock oil pan. The oil filter was easily removed even with the 1 ½” kick out on the Milodon pan.

The steering column must be installed per the chassis builders instructions for clearance with the header. Our design fits side motor mounts or motor plates and the front sway bar kit. It has good spark plug room, some spark plugs can be easily removed with a socket and an extension some will require a socket and end wrench.

This header will fit a power brake booster, but will NOT fit clutch linkage or column shifter linkage. ( ask Dan about clutch linkage ) It requires a mini starter, Hitachi or Nippondenso style a full sized GM starter will not fit. If a Lakewood style scatter shield is used you will have to slightly trim the outer edge below the starter.

We offer Power Master #9540 starters.

Header Installation:

Driver side, remove the spark plugs, oil filter and the center section of the steering column between the “U” joints. You do not have to raise the engine, the header will install from the bottom.

Passenger side, remove the spark plugs and starter. You do not have to raise the engine, the header will install from either the top or the bottom. Before bolting the header in place reinstall the starter.

Refer to our header installation tip’s page for additional information.

Thank you for selecting Lemons Headers!
If you have any questions, give us a call at 805-239-8998
Dan Lemons

Note: Our products do not come coated. They come either with a bare metal shop finish or a high temperature black paint.

Back to the Product List
Home | Product List | Apparel | Price List | Customer Cars | FAQ's | Install Tip | Policies | Contact Us
Lemons Headers Online. Copyright © 2000-2004 Lemons Headers. All Rights Reserved.
Website maintained by WebIQ Media. www.webiqmedia.com